Lanier AP3200 manual Other Printing Problems, Status, Possible Causes, Descriptions, and Solutions

Other Printing Problems

Other Printing Problems

Status	Possible Causes, Descriptions, and Solutions
The area on the page that should	Adjust the image density correctly. ⇒ P.93 “Using the Opera-
be white or free of toner is a	tion Panel”
hazy gray.
The edge of the paper is hazy	If paper is curled, correct it.
gray.	Replace with corrected paper.
	If you start printing on wide paper after printing on many
	narrow pages, the edge of the paper may be hazy gray. In
	this case, print two or three pages to check that paper is not
	dirty.
The back of the printed output is	Check if the size selected with the paper tray dial matches	4
hazy gray.	that selected with the operation panel. If not, select the cor-
	rect size that matches the size and feed direction of the paper
	loaded in the tray.
	If you print something after printing on the paper whose size
	is smaller than the actual document size, the back of the next
	output might be hazy gray. ⇒ P.31 “Loading Paper and Other
	Media”
Image quality varies when	Switch to “Non-Standard Paper” mode by switching the le-
printing on thick paper or on	ver inside of tray 2. ⇒ P.34 “Loading Thick Paper, Envelopes or
OHP transparencies.	OHP Transparencies”
Print image is too light.	Make the image density darker. ⇒ P.93 “Using the Operation
	Panel”
	If Toner Saving mode is selected using the printer driver, the
	whole image gets lighter. See the printer driver's Help.
Print image is too dark.	Make the image density lighter. ⇒ P.93 “Using the Operation
	Panel”
Some parts of the print image	Due to a sudden change in temperature, condensation might
are not clear.	appear inside the printer, and reduce the print quality. If this
	occurs when you move the printer from a cold room to a
	warmer room, do not use the printer until it acclimatizes to
	the temperature.
Multiple pages are fed through	Clean the friction pad, if it is dirty. ⇒ P.82 “Cleaning the Fric-
the printer at once.	tion Pad”
	Clean the pad inside of the tray, if it is dirty. ⇒ P.83 “Cleaning
	the Pad inside of the Tray”
Image is printed on the reverse	Set the paper upside down.
side of the paper.

61