Lanier AP3200 If the printer is using I/O Timeout, allel cable, Network connection, •Windows

Troubleshooting

	Possible Cause	Solutions
	Is the Data In indicator	If the Data In indicator stays off, data is not being sent to the print-
	blinking or lit after starting	er, or the printer may be resetting the print job because there was
	the print job when using	a long delay in receiving the data from the computer.
	the PCL printer driver?	❖ If the printer is using "I/O Timeout"
		Increase the value of the "I/O Timeout" setting of "System" of
		"Job Control". ⇒ P.93 “Using the Operation Panel”
		❖ If the printer is connected to the computer using the par-
		allel cable
		Confirm that the printer port settings are correct. For a parallel
		port connection, port LPT1 or LPT2 should be set.
		For more information about the printer port settings, see the
		note after this table.
4		❖ Network connection
		Contact your network administrator.

If you cannot solve the problem by taking the above actions, contact your sales or service representative.

Note

❒The following procedure describes how to configure the printer port settings.

•Windows 95/98/Me

A Click [Start], point to [Settings], and then click [Printers].

B Click the icon of the printer. Next, on the [File] menu, click [Properties].

C Click the [Details] tab.

D Check the [Print to the following port:] list to confirm the correct port is se- lected.

•Windows 2000

A Click [Start], point to [Settings], and then click [Printers].

B Click the icon of the printer. Next, on the [File] menu, click [Properties].

C Click the [Port] tab.

D Confirm that the correct port is selected.

•Windows NT 4.0

A Click [Start], point to [Settings], and then click [Printers].

B Click the icon of the printer. Next, on the [File] menu, click [Properties].

C Click the [Port] tab.

D Confirm that the correct port is selected.

•Macintosh

A Click [Apple Menu], point to [Control Panels], and then select [Apple Talk].

B Confirm that [Ethernet] is selected in the [connect via:] list.

60