Lanier AP3200 manual Paper and Other Media Supported by This Printer, Paper Types and Sizes

3. Paper and Other Media

Paper and Other Media Supported by This Printer

Paper Types and Sizes

This section describes the type, size, feed direction, and maximum amount of pa- per that can be loaded into each paper tray in this printer.

Important

❒If you use damp or curled paper, misfeeds might occur. In such a case, try turning over the paper stack in the paper tray. If there is no improvement, change to paper with less curl.

❒Be sure to set the paper size dial to match the actual paper size loaded in the tray. When the actual paper size is not shown on the dial, set the dial to “p” and select the paper size using the operation panel.

❒For tray 1, 2, 3 and 4, the dial setting overrides settings selected with the op- eration panel.

Note

❒The following conventions are used to describe paper feed direction:

Example on the panel display	Paper feed direction
A4 (210 ⋅ 297)	short-edge feed direction
A4 (297 ⋅ 210)	long-edge feed direction

❒It is recommended that you load paper having the size and direction you fre- quently use in the tray selected with “Tray Priority”. For more information about Tray Priority, see P.99 “Job Control Menu”.

❒When loading paper having the same size in more than one tray, it is recom- mended that you load paper in the same direction.

❒For more information about the meanings of symbols, see the notes at the bot- tom of each table.

Reference

For more information about loading each type of paper, see P.31 “Loading Pa- per and Other Media”.

17