Lanier AP3200 manual Photoconductor Unit, Job Control Parameters

Error & Status Messages on the Operation Panel

Messages	Description	Comments
Replace	It is time to replace Photo Con-	Replace Photo Conductor Unit
PCU	ductor Unit Type 320.	Type 320. ⇒ P.77 “Replacing
		the Photoconductor Unit”
Reset Duplex	AD380 (duplex unit) is not set	Set AD380 (duplex unit) cor-
Unit Correctly	correctly.	rectly.
Reset Fusing	There is no fusing unit, or the	Install the fusing unit proper-
Unit Correctly	fusing unit is not installed	ly. For more information
	properly.	about the fusing unit, see the
		"Maintenance Kit Type 270
		Replacement Guide" that
		comes with the kit.
Reset PCU	There is no Photo Conductor	Install Photo Conductor Unit
Correctly	Unit Type 320, or Photo Con-	Type 320 again. For more in-
	ductor Unit Type 320 is not in-	formation about Photo Con-
	stalled properly.	ductor Unit Type 320, see the
		"Photo Conductor Unit Type
		320 Replacement Guide" that
		comes with the photoconduc-
		tor unit.
Resetting Job...	Resetting print job.	Wait for a while.
Reset Tray#	There is no paper tray, or the	Set the tray correctly.
Correctly	indicated tray is not set cor-
	rectly.
	# : Tray Number

	Note
	❒ This message appears only
	for the default tray. ⇒ P.99
	“Job Control Parameters”
Setting Changed	The paper feed unit setting has	Configure the paper feed unit
Cannot Print	been changed, and the sample	correctly, and try again.
	print failed.
Waiting...	Printer is waiting for the next	Wait for a while.
	data to print.
Warming Up...	The printer is now preparing	Wait until the printer is
	for printing.	warmed up.

Note

❒If you cannot solve the problem by taking above actions, turn the power off and then back on again. If this does not clear the error message, write down the error number and the message, and contact your sales or service represen- tative.

4

47