Lanier AP3200 manual Removing Misfed Paper, When Misfeed a Appears, Open lower right cover

Troubleshooting

Removing Misfed Paper

4

When a paper misfeed occurs, an er- ror message appears on the panel dis- play. The procedure you should follow to remove the misfed paper depends on the location of the mis- feed, which is indicated on the panel display.

RCAUTION:

•When removing misfed paper, do not touch the fusing section because it becomes very hot.

Important

❒More than one misfed area might be indicated. In this case, check ev- ery applicable area. See the follow- ing illustration.

ZAEY060E

The symbols “E”, “R” and “Z” in the illustration above are not used in the error message. They are sub- stituted as follows:

E ⇒ mailbox R ⇒ finisher

Z ⇒ duplex unit

❒If paper continues to misfeed, check the following points.

•Confirm that the setting of the paper size dial matches the size and feed direction of the paper loaded in the paper tray.

•Confirm that the paper tray guides are set in place.

•Confirm that the top of the stack is not higher than the limit mark indicated on the tray guide.

❒If a paper misfeed still occurs, con- tact your sales or service represen- tative.

❒Do not leave any torn paper scraps within the printer.

When "Misfeed: A" Appears

A Open lower right cover 1.

ZAEH040E

B Remove the misfed paper from inside of lower right cover 1.

ZAEH041E

Note

❒If no misfed paper can be seen inside the cover, slide out the paper tray and check the loaded paper, and then return the tray.

64