Menu item
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Job Hold Timeout
Timeouts
Power Saver
Timeouts
Screen Timeout
Timeouts Print Timeout
Disabled
Description
Sets an alarm to sound when the printer requires operator intervention
Available selections for each alarm type are: Off
Single Continuous
Notes:
•Single is the factory default setting for Alarm Control. Single sounds three quick beeps.
•Off is the factory default setting for Cartridge Alarm. Off means no alarm will sound.
•Continuous repeats three beeps every 10 seconds.
Sets the amount of time the printer waits for user intervention before it holds jobs that require unavailable resources and continues to print other jobs in the print queue
Notes:
•30 seconds is the factory default setting.
•This menu item appears only when a hard disk is installed.
Sets the amount of time the printer waits after a job is printed before it goes into a reduced power state
Notes:
•30 minutes is the factory default setting.
•Lower settings conserve more energy, but may require longer
•Select the lowest setting if the printer shares an electrical circuit with room lighting or you notice lights flickering in the room.
•Select a high setting if the printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum
Sets the amount of time in seconds the printer waits before returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive an
Notes:
•90 seconds is the factory default setting.
•When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting.
•Print Timeout is available only when using PCL emulation. This setting has no effect on PostScript emulation print jobs.
Understanding printer menus
