Lexmark dn3, 410, 5026, 4977, 480, 4976, 280, C734 Double-clickPrint Center or Printer Setup Utility

3Click +.

4Click AppleTalk.

5Select the printer from the list.

6Click Add.

In Mac OS X version 10.4 and earlier

1From the Finder desktop, choose Go > Applications.

2Double-click Utilities.

3Double-clickPrint Center or Printer Setup Utility.

4From the Printer List, click Add.

5Choose the Default Browser tab.

6Click More Printers.

7From the first pop-up menu, choose AppleTalk.

8From the second pop-up menu, select Local AppleTalk zone.

9Select the printer from the list.

10Click Add.

Note: If the printer doesn't show up in the list, you may need to add it using the IP address. Contact your system support person for assistance.

Changing port settings after installing a new network Internal Solutions Port

When a new network Lexmark Internal Solutions Port (ISP) is installed in the printer, the printer configurations on computers that access the printer must be updated because the printer will be assigned a new IP address. All computers that access the printer must be updated with this new IP address in order to print to it over the network.

Notes:

•If the printer has a static IP address that will stay the same, then you do not need to make any changes to the computer configurations.

•If the computers are configured to print to the printer by a network name that will stay the same, instead of by IP address, then you do not need to make any changes to the computer configurations.

•If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure the wired network is disconnected when you configure the printer to operate wirelessly. If the wired connection remains connected, then the wireless configuration will complete, but the wireless ISP will not be active. In the event that the printer was configured for a wireless ISP while still attached to a wired connection, disconnect the wired connection, turn the printer off, and then turn the printer back on again. This will enable the wireless ISP.

•Only one network connection at a time is active. If you want to switch the connection type between wired and wireless, you must first turn the printer off, connect the cable (to switch to a wired connection) or disconnect the cable (to switch to a wireless connection), and then turn the printer back on again.

For Windows users

1Print a network setup page and make a note of the new IP address.

2Click , or click Start and then click Run.

Additional printer setup

46