The second tab at the top of the NMEA 2000 Alarms page is the Alarm Status Tab. When an alarm has been set for a device, the alarm and its current status will be shown on the Alarm Status window. To view the Alarm Status window, highlight the Alarm Status tab and press ENT.
To set NMEA 2000 Alarm:
1.Press MENUMENU, select NMEA 2000 and press ENT.
2.Highlight NMEA 2000 ALARMS and press ENT.
3.Highlight FLUID LEVEL DEVICE and press ENT. Use ↑ ↓ to select the de- vice you want to set an alarm for and press ENT.
4.Highlight the ENABLED box next to the desired alarm (Full Alarm or Empty Alarm) and press ENT to turn on the alarm.
5.To set the alarm percentage, press → to highlight PERCENT and press
ENT.
6.Use ↑ ↓, ← → to input the desired percentage and press ENT. Repeat Steps
7.Highlight SET CONFIGURATION and press ENT to finalize alarm settings. Press EXIT repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its ENABLED BOX and press
ENTER.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit with display units across the network.
To turn on/off Waypoint Sharing:
1.Press MENUMENU, select NMEA 2000 and press ENT.
2.Highlight WAYPOINT SHARING and press ENT which will turn on/off way- point sharing.
3.Press EXIT repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit backlight levels consistent across the NMEA 2000 network. So, if you set the backlight level to 75% on one display unit, all other units on the network will automatically switch to the same setting.