For connectors and wiring information for another device, see page 36. For assistance in configuring the unit to communicate with another device, consult the factory. Customer service phone numbers are in the back of this manual.
Configure NMEA
You can configure the unit to use specific NMEA sentences.
1.Press MENUMENU↓ to SYSTEM SETUPENT.
2.Press ↓ to COMMUNICATIONS PORTENT↓ to CONFIGURE NMEAENT.
3.A menu appears showing the prefixes of the available NMEA sen- tences. A check mark next to a prefix means the prefix is in use. Use ↑ ↓, ← → to select a prefix, then press ENT to turn off the prefix. (Press ENT again to check the box and turn on a prefix.)
4.When the desired prefixes are checked or unchecked, press EXIT re- peatedly to return to the previous page.
NOTE:
Placing a check in the checkbox next to Radar at the bottom of the Communications Port menu will set the Baud Rate to the default Radar Baud Rate setting.
Coordinate System Selection
The Coordinate System Menu lets you select the coordinate system to use when displaying and entering position coordinates.
Menus for changing coordinate system used to display positions.
To get to Coordinate System Selection:
1.Press MENUMENU↓ to GPS SETUPENT.
2.Press ↓ to COORDINATE SYSTEMENT.
This unit can show a position in degrees (36.14952°); degrees, minutes and thousandths of a minute (36° 28.700'); or degrees, minutes, seconds and tenths of a second (36° 28' 40.9"). It can also show position in: UTM
