Lowrance electronic LMS-520C, LMS-525C DF

229

Highlight CALIBRATE TRIM and press ENT. The Device Calibration window

will appear with a list of Calibration Instructions.

4. Highlight START CALIBRATION and press ENT. The following message

will appear: Please fully raise the Engine Trim.

5. After engine trim has been fully raised, press ENT. The following

message will appear: Please fully lower the Engine trim.

6. After engine trim has been fully lowered, press ENT. A Calibration

Completed message will appear. Press ENT.

7. Repeat these instructions to adjust the engine trim for each engine

connected to a Suzuki Engine Interface. Press EXIT repeatedly to return

to the main display.

Reset Trim Calibration

If you are not satisfied with your engine trim calibration, you can reset

engine trim calibration from the Suzuki Engine Interface Advanced

Options menu.

1. Press MENU|MENU, select NMEA 2000 and press ENT.

2. Choose BUS SETUP and press ENT. Select the Suzuki Engine Interface

connected to the desired engine and press ENT.

3. Highlight ADVANCED OPTIONS and press ENT. Select Reset TRIM CALIBRA-

TION and press ENT. The following message will appear: Do you wish to

re-calibrate the device?

4. Highlight YES and press ENT. Press EXIT repeatedly to get back to the

main display.

Bennett Trim Tabs Calibration

Trim Tabs will be calibrated through their Device Configuration menu.

To calibrate Trim Tabs:

1. Press MENU|MENU, select BUS SETUP and press ENT. A list of network

devices will appear.

2. Select BENNETT TRIM TABS from the list and press ENT, which will open

the Trim Tab Device Configuration menu.

3. Highlight CALIBRATE and press ENT. The Device Calibration window

will appear with a list of calibration instructions.

4. Select START CALIBRATION and press ENT. The following message will

appear: Please fully raise Trim Tabs.

5. After fully raising the trims tabs, press ENT. The following message

will appear: Please fully lower trim tabs.

6. After fully lowering the trim tabs, press ENT. A Calibration Complete

message will appear. Press ENT. Press EXIT repeatedly to return to the

main display.