1.Press MENU MENU, use ↓ ↑ to select NMEA 2000 and press ENT.
2.Highlight BUS SETUP and press ENT, which will open the Bus Configu- ration menu. A list of network devices will be at the top of the page.
3.Select the desired
4.Press ↓ to select CALIBRATE and press ENT. The Device Calibration menu will appear.
5.Highlight NUM PTS, press ENT and select 5. Press ENT.
6.Make sure your tank is empty, then highlight FLUID LEVEL and press ENT. Select EMPTY LEVEL and press ENT.
7.Select CALIBRATE and press ENT. The following message will appear: Empty Level Calibration Completed. Press ENT.
8.Add 1 quarter tank of fuel, highlight FLUID LEVEL and press ENT. Select
1QTR LEVEL and press ENT.
9.Select CALIBRATE and press ENT. The following message will appear: 1 Qtr Level Calibration Completed. Press ENT.
10.Add another quarter tank of fuel, which should raise the fuel level to half a tank. Highlight FLUID LEVEL and press ENT. Select HALF LEVEL and press ENT.
11.Highlight CALIBRATE and press ENT. The following message will ap- pear: Half Level Calibration Completed. Press ENT.
12.Add another quarter tank of fuel, which should raise the fuel level to 3 quarters of a tank. Highlight FLUID LEVEL and press ENT. Select 3 QTR LEVEL and press ENT.
13.Select CALIBRATE and press ENT. The following message will appear: 3 Qtr Level Calibration Completed. Press ENT.
14.Top off the tank, highlight FLUID LEVEL and press ENT. Select FULL LEVEL and press ENT.
15.Select CALIBRATE and press ENT. The following message will appear: Full Level Calibration Completed. Press ENT, then press EXIT repeat- edly to get back to the main display.
Fuel Flow Calibration in a Suzuki Engine Interface
The default calibration for the Suzuki Engine Interface is adequate in most cases, but if Fuel Used readings are off by more than 3 percent, calibration is recommended.
To check engine interface accuracy:
Select Fuel Used to be shown as Overlay Data on your unit's main dis- play. Refer to the Overlay Data segment of this manual for instructions on how to select Fuel Used data as Overlay Data.
