Microsoft 2045 appendix Jbig Reception, Transfer result report, Transfer Stations Quick Dial

Reception Features

-Sending the transfer result report

This machine compares the fax number of the Requesting Party with the Requesting Party's number pro- grammed as a Quick Dial or Speed Dial. If the lower five digits of the two numbers match, it sends the Transfer Result Report to the Requesting Par- ty.

For example:

•Requesting Party's own dial number:

	001813-11112222
	• Transfer Station's Quick Dial:
5
	03-11112222

Transfer result report

This reports whether transmission to the End Receivers was successful or not.

Preparation

Program the Requesting Party fax number into a Quick Dial key in advance.

Program your own fax number.

See p.169 “Transfer Report”.

Program the Polling ID. See p.170 “Programming a Polling ID”.

When the Transfer Station has trans- ferred the message to all End Receiv- ers, it sends the Transfer Result Report back to the Requesting Party. The machine prints the report if it cannot be sent back to the Requesting Party. You must program the fax number of the Requesting Party as a Quick Dial in the Transfer Station.

Note

❒You can set whether a portion of the original image is printed on the report with the User Parameters. See p.147 “Changing the User Pa- rameters” (switch 04, bit 7).

JBIG Reception

The optional fax function upgrade unit is required.

If you use JBIG (Joint Bi-level Image Experts Group) compression, you can send photographic originals faster than with other methods of compres- sion. You can only use this function with G3 line type. It allows you to re- ceive messages sent in the JBIG for- mat through JBIG Transmission.

Limitation

❒If ECM is turned off, JBIG Recep- tion is unavailable.

Note

❒When the optional extra G3 inter- face unit is installed, JBIG recep- tions of G3-2 and G3-3 lines are as standard.

82