Microsoft 2045 appendix Checking the Transmission Result, Automatic Redial, Batch Transmission

Other Transmission Features

Checking the Transmission

Result

•Turn the Transmission Result Re- port on if you want a report to be printed after every successful transmission. See p.18 “Memory Transmission”, Facsimile Reference <Basic Features>.

•If you leave the Transmission Re- sult Report off, the report will not be printed after every transmis-

sion. However, if a transmission

4 fails, a Communication Failure Re- port will be printed instead. See p.75 “Communication Failure Re- port”.

•You can also check the transmis- sion result by examining the Jour- nal . S ee p . 23 “ Printing the Journal”.

•You can either print or scroll through the Journal on the display. See p.27 “Checking the Transmis- sion Result (TX File Status)”.

Automatic Redial

If a fax message could not be trans- mitted because the line was busy or an error occurred during transmis- sion, redialing is done five times in five minutes intervals (these figures vary according to which country you are in).

If redialing fails after four redials, the machine cancels the transmission and prints a Transmission Result Report or Communication Failure Report.

Batch Transmission

If you send a fax message by Memory Transmission and there is another fax message waiting in memory to be sent to the same destination, that message is sent along with your orig- inal. Several fax messages can be sent with a single call, thus eliminating the need for several separate calls. This helps save communication costs and reduce transmission time.

Fax messages for which the transmis- sion time has been set in advance are sent by batch transmission when that time is reached.

Note

❒You can turn this function on or off with the User Parameters. See p.147 “Changing the User Parame- ters” (switch 14, bit 2).

❒The originals to be transmitted at a specific time will be sent at that time.

❒If fax memory is overloaded, mes- sages may not be sent in the order they were scanned.

ECM (Error Correction Mode)

This function automatically sends data that was not transmitted suc- cessfully using a system that complies with international standards.

ECM requires that the destination machine has the same function.

Note

❒You can turn this function on or off using the Key Operator Settings. See p.146 “ECM”.

72