Mitsubishi Electronics LT-3280 Appendix a Specifications, Display and Media Center Specifications

Appendix A: Specifications

Software Updates: From time to time, Mitsubishi may offer software updates to expand the features or operation of this media center. When these updates are available they will be announced on our web site, Mitsubishi-tv.com. If you return your Owner’s registration card, with your model and serial number, you may receive written notification of available software updates.

Display and Media Center Specifications

Channel Frequency Reception	Over-the-Air: VHF 2 - 13, UHF 14 - 69
	Analog Cable: 1 - 125
	Digital Cable: 1 - 135
Channel Type	Over the Air: Analog NTSC, Digital ATSC with sub-channels
		(all 18 video formats)
	Cable:	Analog NTSC (non-scrambled)
		Digital QAM 64 and 256 with sub-channels (non-scrambled)
	CableCARD™: Authorized scrambled and non-scrambled digital channels

Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and can vary from the standard frequency number. If there is no channel number information included from the broadcaster or cable company, then the TV will create a channel number based on the frequency number as the main channel number and the program number as the sub-channel number. When using an authorized CableCARD, the channel numbers are determined by the cable company.

Inputs

Antenna/Cable input, Qty 2	F connector, 75 ohm
HDMI (digital video/audio), Qty 2	HDMI standard connectors (on media center)
Signal Type	HDMI standards for digital audio and video. Not intended for use with personal
	computers
Video/S-Video, Qty 2 each	Video: RCA Pin Plug, 1.0 V p-p, 75 ohm
	S-Video: Four Pin DIN Plug
	Y: 1.0 Vp-p 75 ohm
	C: 0.286 Vp-p (burst signal), 75 ohm
Signal Type	NTSC 480i only
Component Video (Y/Pr/Pb), Qty 2 sets	RCA Pin Plug (EIA-770.3 Standard Levels and Timing)
	Y: 1.0 Vp-p (includes sync), 75 ohm
	Pr: 700 mVp-p, 75 ohm
	Pb: 700 mVp-p, 75 ohm
Signal Type	EIA-770.1 & EIA 770.2 480i, 480p, EIA 770.3 720p and 1080i (video standards)
PC Input (RGB), Qty 1	Mini-D Sub, 15 pin (Note: located on display rear panel)
Signal Type	VGA, SVGA, XGA, WXVGA, SXGA
Audio Inputs, Qty 6 pair	RCA Pin Plug 500mV (full scale), 43kohm
MonitorLink™ Control	RS-232C NOTE: Must connect to MonitorLink™ RS-232C terminal on display.

Outputs

Video

Monitor Output, Qty 1	Video: RCA Pin Plug 1.0 Vp-p, 75 ohm
Signal Type	NTSC 480i only for recording only
Audio
Monitor Output, Qty 1 pair	RCA Pin Plug, 500 mV rms + 200 mV (full scale) for analog sources.
	1.5 V + 0.5 V (full scale) for digital sources.
Audio Line Out, Qty 1 pair	RCA Pin Plug, 500 mV rms + 200 mV (full scale) for analog sources.
	1.5 V + 0.5 V (full scale) for digital sources.
	Fixed audio ouput when connected to A/V Receiver.

94