
Chapter 5: Using the TV Menu
Antenna Menu
Figure 14
Figure 14. Antenna Menu
The Antenna Menu options are available for use with analog and digital channels on
Memorize
For Antenna 1 (Main) or Antenna 2 (Aux)
Select either Air (when used with an indoor/outdoor antenna) or Cable (when used with direct cable) then press ENTER to start the automatic channel memorization process. If a CableCARD™ is being used, memorized channels are provided by your cable provider through the CableCARD.
To stop the automatic channel memorization process, press CANCEL. Channels memorized before you pressed CANCEL are retained in memory.
After memorizing channels, the channels in the memory can be accessed in ascending or descending order by pressing CH or
.
The memorization will occur twice, as the media center memorizes analog and digital channels separately.
Prefer Digital
When a memorized channel is available as both analog and digital, a check mark in the Prefer Digital box will allow digital channels to display and analog channels to be hidden (when using CH). Removing the checkmark will show both analog and digital choices. This function is unavailable (grayed out) when TV Guide On Screen® has been set up
Channel
Channels can be changed in 3 ways:
1.By pressing ADJUST or
to select the channel.
2.By pressing CH or
for channels already in memory.
3.Directly entering the number. With so many current and potential channels, the number range is greatly expanded. Channels can be one part, analog or digital (up to the number 16383) or two part, for digital channels (these use a separator). For a two part digital channel, you may press SUB/CANCEL on the remote to enter a separator after the first, second or third number, depending on the broadcaster’s channel information.
For digital channels, when the broadcaster has sent a virtual channel number, the virtual channel number is shown in the text box and as a reference, the original digital channel is shown below the text box.
Memory
After the available channels have been memorized with Memorize, weaker channels can be added. Unwanted channels can also be deleted. Press CH or
on the remote control to see the channels in memory. Press ADJUST
or
to select Added or Deleted for the channel shown in the Channel number box.
Name
Analog channels shown on
1.Press ADJUST or
to select each letter.
2.Press ENTER to set the letter and move to the next letter position.
3.Press CANCEL to move back one position.
Digital channels are automatically named if the broadcaster sends the information.
69