Mitsubishi Electronics LT-3780, LT-3280 manual Wall Outlet Cable, Cable Box

Chapter 2: Connecting

Wall Outlet Cable

(can be used with a CableCARD™)

Figure 4

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use.

1.Connect the primary incoming coaxial lead cable to ANT-1 MAIN on the media center rear panel.

2.For an optional secondary antenna source, connect an antenna (or cable) to ANT-2 AUX.

3.If you have subscribed to a CableCARD™ service, the CableCARD can now be inserted into the CableCARD SLOT. The top of the card should face upwards. Additional CableCARD information is on page 23.

.FEJB
$FOUFS 

$BCMF$"3%5.

4MPU

Figure 4. Wall Outlet Cable */

*/



0QUJPOBM

4FDPOEBSZ

"OUFOOB

PS
$BCMF

*/



1SJNBSZ
8BMM

0VUMFU
$BCMF

Cable Box

Figure 5

3 coaxial cables and one two-way RF splitter are required. These are not included with the media center.

It is very important to connect the incoming cable for your primary viewing source to ANT-1, especially for CableCARD™ use.

1.Connect the incoming cable to IN on an RF splitter.

2.Connect one coaxial cable from OUT on the RF splitter to ANT-1 MAIN on the media center rear panel.

3.Connect one coaxial cable from OUT on the RF splitter to IN on the cable box.

4.Connect one coaxial cable from OUT on the cable box to ANT-2 AUX on the media center rear panel.

 */

*/

065

065

$BCMF
#PY

.FEJB
$FOUFS CBDL
QBOFM
TFDUJPO

 */  */

Figure 5. Connecting a Cable Box

 065	065		580 8":	 */
			41	*/
		065	-*55&3

 065

4QMJUUFS

1VSDIBTFE
4FQBSBUFMZ *ODPNJOH $BCMF

IMPORTANT

Additional connection cables are not provided with the product. They are available at most electronic stores.

NOTE: Net Command® will assume that your Cable Box is connected as shown here. Also, that Channel 3 is the default output channel for the cable box. If either the connections or output channel are different, use the Change option of Edit NetCommand to apply the changes.

21