Chapter 1: Product Overview
1 | 17 | |
2 | 18 | |
3 | 19 | |
| ||
4 | 20 | |
| ||
5 | 21 | |
6 | 22 | |
| ||
7 | 1"(& | |
23 | ||
| ||
8 | 24 | |
9 | 25 | |
10 | 26 | |
11 | 27 | |
12 | ||
28 | ||
| ||
13 | 29 | |
| ||
14 | 30 | |
31 | ||
| ||
15 | 32 | |
| 33 |
16
34
Figure 1. Remote Control Overview
Remote Control Operation
Battery Installation
Figure 2
Installing the Batteries:
1.Remove the remote control’s rear cover by gently pressing the ribbed tab in the direction of the arrow and sliding off the cover.
2.Load the batteries, making sure the
"" BMLBMJOF CBUUFSJFT
Figure 2. Operation: Installing the Batteries
Care
For Best Results from the Remote Control:
•Be within 20 feet of the equipment.
•Do not press two or more buttons at the same time unless instructed.
•Do not allow unit to get wet or become heated.
•Avoid dropping on hard surfaces.
•Do not use harsh chemicals to clean. Use only a soft cloth, lightly moistened with water.
•Do not mix new and old batteries.
•Do not heat, take apart or throw batteries into fire.
•Use only AA alkaline batteries.
Hint: If the remote is in the Cable/DBS/DTV layer and will not operate the media center, press and hold POWER and enter 1, 9, 7 to reset the remote control.
Sleep Timer
Setting the Sleep Timer:
1.Press SLEEP on the remote control.
2.Each press of SLEEP increases the time displayed by 30 minutes, until the maximum value of 120 minutes is reached.
3.After 5 seconds of inactivity, the message will disappear.
4.Press SLEEP to view the remaining time before the timer turns the TV off.
Canceling the Sleep Timer:
1.Press SLEEP to display the
2.Press SLEEP repeatedly until OFF is displayed.
Note: After 5 seconds of inactivity, the message box disappears.
13
