Mitsubishi Electronics LT-3280, LT-3780 manual Receiver or Stereo System, 
065, 
065

Chapter 2: Connecting

A/V Receiver or Stereo System

Figure 10

A digital audio cable and stereo audio cables are required. The digital audio cable is provided. The stereo audio cables are not included with the media center. “Y” splitter cables may also be required.

1.Connect a set of stereo audio cables from AUDIO LINE OUT on the media center rear panel to the TV AUDIO INPUT on the back of the A/V receiver. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel.

To connect a digital A/V receiver with Dolby® Digital surround sound:

2.Connect one end of the digital audio cable supplied with the media center to DIGITAL AUDIO on the back of the media center. Connect the other end to the COAXIAL DIGITAL INPUT on the back of the A/V receiver.

Check A/V receiver’s Owner’s Guide for information concerning the use of the digital input and switching between the digital sound and analog stereo sound from the display.


065

 065	015*$"-
	*/165

*/165 

*/ $0"9*"-

*/165 $0"9*"-

%*(*5"-
"6%*0

				8IJUF					ΤΣ
											-
											3
				3FE		*/
		$%						57
	"69		5"1& 	5"1& 	7$3 		7$3 			%7%
						 */
.FEJB $FOUFS											"7 3FDFJWFS

3FBS
1BOFM

6TF
POMZ
JG
DPOOFDUJOH
B %JHJUBM
"7
3FDFJWFS

Figure 10. Connecting an A/V receiver

Satellite Receiver or Other S-Video Devices

Figure 11

An S-Video cable and audio cables are required. These are not included with the TV sytem.

1.Connect an S-Video cable from VIDEO OUT on the satellite receiver rear panel to INPUT-2 VIDEO on the media center rear panel.

2.Connect a set of audio cables from AUDIO OUT on the satellite receiver rear panel to INPUT-2 AUDIO, on the media center rear panel. The red cable connects to the R (right) channel and the white cable connects to the L (left) channel. Refer to the Satellite Receiver Owner’s Guide for Dish Antenna connections.

8IJUF	3FE
	
*/	*/

8IJUF	"6%*0 065	"6%*0 */		7*%&0 065
	-	-	:$



3 3 
065

3FE 
065

BOZ
47JEFP
%FWJDF

Figure 11. Connecting a Satellite Receiver with S-Video

.FEJB
$FOUFS

Note: NetCommand® will assume you connected your Satellite Receiver to Input-2. If you add a second Satellite Receiver or use any other inputs for your Satellite Receiver, this change must match in the NetCommand system. See Editing NetCommand Setup in Chapter 3 for more information.

26