Appendix H: Remote Control Programming Codes, continued

IMPORTANT

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, the HDTV receiver/contoller remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

After entering the correct codes in each position of the remote control, use the slide switch to select which product will respond when an operational button is pressed. Only one of the below devices is allowed for each slide switch position.

TV position:

Mitsubishi TVs Cable/DBS/DTV position:

Media Center (provided)

NetCommand® controlled devices DVD position:

DVD player

LD player

VCR position:

VCR

Audio position:

A/V receiver

DVD player

Cable box

If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to 010.

When your remote control has been programmed to operate another manufacturer’s product, the function performed on each layer can vary. The most common functions are:

VCR

POWER

CHANNEL up/down

PLAY

REC

PAUSE

STOP

FF/FWD

REW/REV

Mitsubishi VCRs will be compatible with some additional buttons

Cable Boxes and Satellite Receivers

POWER

CHANNEL up/down

0-9 number buttons (on some models)

ENTER (on some models)

CANCEL (on some models)

ADJUST up/down/ left/right (on some models)

GUIDE (on some models)

A/V Receivers

POWER

VOLUME

MUTE

Mitsubishi A/V Receivers

Direct Input Selection buttons: numbers, SQV and QV (on some models)

Mitsubishi CD Players

(not all functions for all models)

PLAY

FF/FWD

REW/REV

PAUSE

STOP

DVD and Laser Disc Players (not all functions for all models)

POWER

MENU

0-9 number buttons (on some models)

PLAY

STOP

ARROW up/down/left/right (on some models)

FF/FWD

REW/REV

PAUSE

CANCEL (on some models)

ENTER

CHANNEL (on some models)

106

Page 112
Image 112
Mitsubishi Electronics LT-3280, LT-3780 manual 106