Mitsubishi Electronics LT-3280 manual Antenna with Twin Flat Leads, Separate UHF and VHF Antennas

Chapter 2: Connecting

Antenna with Twin Flat Leads

(not for use with CableCARD™)

Figure 6

For an antenna with twin flat leads:

A 300-ohm to 75-ohm transformer is required. This is not included with the media center, but is available at most electronics stores.

1.For antenna with twin flat leads, connect the 300-ohm twin leads to a 300-ohm to 75-Ohm transformer (purchased separately).

2.Push the 75-ohm side of the transformer onto ANT-1 MAIN on the media center rear panel.

OR For cable or an antenna with coaxial lead:

3. Connect the coaxial lead directly to ANT-1 MAIN on the media center rear panel.

.FEJB
$FOUFS

PIN PIN

$PBYJBM
5XJO
'MBU

$BCMF -FBET



PS 

.BUDIJOH
5SBOTGPSNFS

1VSDIBTFE
4FQBSBUFMZ

PIN
UP

PIN

Figure 6. Connecting an Antenna with Twin Flat Leads

NOTE: Mitsubishi strongly recommends that you use an antenna with coaxial cable—NOT an antenna with twin flat leads. Twin flat lead antenna wires are subject to interference which may adversely affect the performance of the TV.

Separate UHF and VHF Antennas

Figure 7

A UHF/VHF combiner is required. This is not included with the media center.

1.Connect the UHF and VHF antenna leads to the UHF/VHF Combiner.

2.Insert the Combiner into ANT-1 MAIN on the media center rear panel.

		7)' "OUFOOB
		$IBOOFMT 
.FEJB $FOUFS	6)' "OUFOOB
	$IBOOFMT 			&YUFSOBM
				"OUFOOB
		$PNCJOFS	'MBU 5XJO	PS $BCMF
	1VSDIBTFE 4FQBSBUFMZ		-FBE
	 PIN UP  PIN
	6)'			'MBU 5XJO
*/	7)'			-FBE

4JEF #BDL



Figure 7. Connecting separate UHF and VHF Antennas

22