Mitsubishi Electronics LT-3780, LT-3280 manual Stand Removal Instructions, Wall Mount Kit

Stand Removal Instructions

CAUTION

•A minimum of TWO PEOPLE are needed to safely remove the stand.

•One person needs to hold the stand while the other person removes the stand screws. This is necessary to prevent the stand from falling to the floor.

•Failure to follow these recommendations may result in personal injury as well as damage to the product.

1. Before performing work, make sure to		%JTQMBZ	4UBOE
disconnect the AC power cord from the display.	1SPUFDUJWF
	TIFFU

2.Before performing work, spread the protective sheet that was wrapped around the display on a flat, even surface (such as a table). The protective sheet will prevent the display from being damaged.

5BCMF

3.	Gently place the display face down on the	Step 4: Remove the
	protective sheet with the display stand hanging
		small cover to access
	over the edge of the table. See the illustration
		stand screws and the
	to the right.
		AC power input.
	CAUTION: The stand is heavy and can fall, so
	two people are needed to safely remove it.			 4UBOE 4DSFXT
4.	Remove the small cover on the back of the		4BGFUZ 5BC
	display. See the illustration to the right. Press			4UBOE
	on the small tab to release the cover. Keep
	the cover and reinstall it after connecting the		%JTQMBZ
	display to the media center.
5.	With the stand hanging over the edge of the
	table, have one person hold the stand firmly
	with both hands while the other person uses a
	screwdriver to remove the six (6) stand screws.
	See the illustration to the right.
6.	While the first person continues to hold the
	stand firmly, have the other person unscrew
	the Safety Tab screw. See the illustration to the
	right.
7.	The person holding the stand can now put the
	stand carefully in a safe place for future use.
8.	The display is now ready for mounting. Refer to		IMPORTANT
	the instructions provided with the Wall Mount		BEFORE MOUNTING THE DISPLAY TO A WALL:
	Kit (purchased separately).
			Be sure to connect a VGA cable to the
Wall Mount Kit			display PC (video) Input, and if applicable,
			a stereo mini cable to the PC Audio Input.
To order a Wall Mount Kit (Part # PSM-2048):			Otherwise, you will not be able to access
			the PC Inputs after wall-mounting.
Please call the Mitsubishi Parts Department at: (800) 553-7278			The media center does not have PC inputs.
or call Chief Manufacuring, Inc. at: (800) 582-6480.			See Chapter 6 for more information.

5