Mitsubishi Electronics LT-3780 Peer-to-Peer Connections, Record List, Cancel Current Recordings

Chapter 4: IEEE 1394 Devices and NetCommand® Controlled Recordings

Record List

Figure 14

Press GUIDE while viewing the Record To screen to see a list of all currently programmed recordings. A maximum of 32 recordings can be scheduled.

Figure 14. Record List screen

Cancel Current Recordings

To cancel a recording in progress, press DEVICE to display the Device Selection menu and highlight the source of the recording. Confirm that the icon for VCR (or recording device) is in the Connection Section next to the TV icon. Press the CANCEL button. The icon for the VCR (or recording device) will disappear from the Connection Section to confirm the cancellation.

To cancel a recording on the Record List, press ADJUST or to select the recording, then press CANCEL. To page through the list, press CH or .

Peer-to-Peer Connections

Apeer-to-peer connection allows the IEEE 1394 devices in your media center network to talk to each other without the further need of media center intervention once the peer-to-peer connection is established. For example, the media center can set up a connection for an or DVCR that sends a recorded program to an IEEE 1394 monitor in another room. NetCommand will establish the connection between the two devices. Once the connection has been established, the media center can be turned off or be used to display another device on the monitor. Recording from digital channels to a DVCR is also a peer-to-peer connection. In this case, the media center is one of the devices in the peer-to peer connection.

NOTE: Multiple peer-to-peer connections can occur simultaneously, sometimes with the same source device.

Setting up a Peer-to-Peer Connection

To establish a peer-to-peer connection:

1.Press CONNECT on the HDTV remote.

2.Press DEVICE on the remote control to move to the Source Device section.

3.Press ADJUST or to select the source device you will record from.

4.Press ENTER to confirm selection and return to the “Record to” section.

5.In the “Record to” section, review the destination device (example: DVCR) and duration. Change if necessary.

5.Press CONNECT a second time to initiate recording.

Canceling a Peer-to-Peer Connection

After a peer-to-peer connection has been established, you can cancel it by highlighting the source device in the Device Selection menu. Confirm that the on-screen icon for the peer-to-peer connection is in the Connection Section next to the TV icon, then press CANCEL. The connection will end and the destination icon will be removed. If there is more than one peer-to-peer connection for the same device, all of the connections will all be canceled.

59