Mitsubishi Electronics LT-3280 TV Guide On Screen System Setup, Review Screen, Finish Screen

Chapter 3: NetCommand® Setup and Editing

NetCommand® Initial Setup, continued

Figure 3. Device Setup screen

Note: If you selected “Other” for any of the device names, the media center can “Learn” the connected device by following the Edit NetCommand instructions. For many device types, non-listed models will operate in the same way as the listed models and you can still use the pre-loaded setting.

TV Guide On Screen® System Setup

Figure 4

The TV Guide On Screen option allows you to select whether you want to enable the Guide and which devices you want to include in the listing. In order to get the correct listings for your area, you will need to enter your 5-digit ZIP code.

Depending on your setup, you can select either or both antenna inputs, or antenna inputs and a cable box, or Cable CARD™ on Antenna 1 and an over-the-air antenna on Antenna 2. If you have multiple cable connections such as direct cable without a box on one antenna and a cable box on the other antenna or an input, these will share the same channel number assignment and as a result may not match correctly for both connections.

For detailed information on using the TV Guide On Screen system, please see the TV Guide On Screen® Interactive Program Guide User’s Manual.

Figure 4. TV Guide On Screen

Note: Inputs to TV Guide On Screen can include only one over-the-air source and one cable souce.

If you connect an HDTV cable box to the TV using Com- ponent 1 or 2, HDMI Input 1 or 2, or IEEE 1394, and plan to use TV Guide On Screen to control this cable box, also connect an over-the-air antenna in order to download TV Guide On Screen data.

Review Screen

Figure 5

After you have made your device choices the Review Screen will display. It is important to review the settings to ensure that they are correct. If necessary, you can use <Back to return to the Device Setup screen to make changes.

Figure 5. Review screen

Note: The Review screen lists the media center input and A/V receiver input used with each device. You must correctly identify the inputs you used when you connected the devices. If you have not connected your devices, write down these inputs as a guide. If you cannot use these inputs, or if you would like to change the name of a device, use the instructions in Edit NetCommand to make necessary changes.

Note: If you select Next> on the Review screen, all selections made are finalized.

On the Review screen, adding or deleting check marks will turn the adjacent devices, memory cards or inputs On or Off. 1394 device names only appear on the Review screen when the devices are connected to the media center.

Finish Screen

Figure 6, next page

To complete the NetCommand setup, select Finish from the Finish screen.

If you wish to change any of the pre-configured inputs or names for the devices, or add devices not in the pre-configured setup, select Edit to display Edit NetCommand menu.

If your A/V receiver (AVR) was not listed, select Edit to add the AVR and then assign all devices to new AVR inputs.

38