National Instruments 320682C

Chapter 10 Easy I/O for DAQ Library

Table 10-5. Easy I/O for DAQ Error Codes (Continued)

-10414 reservedPinErr Selected signal indicates a pin reserved by NI-DAQ. You cannot

configure this pin yourself.

-10440 sysOwnedRsrcErr The specified resource is owned by the driver and cannot be

accessed or modified by the user.

-10441 memConfigErr No memory is configured to work with the current data transfer

mode, or the configured memory does not work with the current data transfer mode.

(If block transfers are in use, the memory must be capable of performing block

transfers.)

-10442 memDisabledErr The specified memory is disabled or is unavailable given the

current addressing mode.

-10443 memAlignmentErr The transfer buffer is not aligned properly for the current data

transfer mode. For example, the memory buffer is at an odd address, is not aligned to

a 32-bit boundary, is not aligned to a 512-bit boundary, and so on. Alternatively, the

driver is unable to align the buffer because the buffer is too small.

-10444 memFullErr No more system memory is available on the heap, or no more memory

is available on the device.

-10445 memLockErr The transfer buffer cannot be locked into physical memory.

-10446 memPageErr The transfer buffer contains a page break; system resources may

require reprogramming when the page break is encountered.

-10447 memPageLockErr The operating environment is unable to grant a page lock.

-10448 stackMemErr The driver is unable to continue parsing a string input due to stack

limitations.

-10449 cacheMemErr A cache-related error occurred, or caching does not work in the

current mode.

-10450 physicalMemErr A hardware error occurred in physical memory, or no memory is

located at the specified address.

-10451 virtualMemErr The driver is unable to make the transfer buffer contiguous in virtual

memory and therefore cannot lock the buffer into physical memory; thus, you cannot

use the buffer for DMA transfers.

-10452 noIntAvailErr No interrupt level is available for use.

-10453 intInUseErr The specified interrupt level is already in use by another device.

-10454 noDMACErr No DMA controller is available in the system.

-10455 noDMAAvailErr No DMA channel is available for use.

-10456 DMAInUseErr The specified DMA channel is already in use by another device.

(continues)