GS700TS Smart Switch Software Administration Manual
Network without a DHCP Server
This section describes how to set up your switch in a network without a DHCP server, and is divided into the following tasks:
•Manually assign network parameters for your switch
•Configure the NIC settings on the host PC
•Log in to the
Manually Assigning Network Parameters
If your network has no DHCP service, you must assign a static IP address to your switch. You can also assign the switch a static IP address even if your network has DHCP service. Proceed as follows:
1.Connect the GS700TS Gigabit Stackable Smart Switch to your existing network.
2.Power on the switch by plugging in the
3.Install the SmartWizard Discovery utility on your computer. The SmartWizard Discovery utility is located on the switch installation CD.
4.Start the SmartWizard Discovery utility.
5.Click Discover for the SmartWizard Discovery utility to find your GS700TS Gigabit Stackable Smart Switch. You should see a screen similar to that shown in Figure
6.Click Configuration Setting. A screen similar to that shown below appears.
Getting Started with Switch Management |
v1.0, June 2009
