NETGEAR RP114 manual Configuring the Macintosh for IP Networking

Reference Guide for the Model RP114 Web Safe Router

To check your PC’s TCP/IP configuration:

1.On the Windows taskbar, click the Start button, and then click Run. The Run window opens.

2.Type winipcfg, and then click OK.

The IP Configuration window opens, which lists (among other things), your IP address, subnet mask, and default gateway.

3.Select your Ethernet adapter.

The window is updated to show your settings, which should match the values below if you are using the default TCP/IP settings that NETGEAR recommends:

•The IP address is between 192.168.0.2 and 192.168.0.31

•The subnet mask is 255.255.255.0

•The default gateway is 192.168.0.1

Configuring the Macintosh for IP Networking

Beginning with Macintosh Operating System 7, TCP/IP is already installed on the Macintosh. On each networked Macintosh, you will need to configure TCP/IP to use DHCP by following these steps:

1.From the Apple menu, select Control Panels, then TCP/IP. The TCP/IP Control Panel opens:

Preparing Your Network 3-5