Reference Guide for the Model RP114 Web Safe Router

LAN Setup

Menu 3 enables you to configure the Ethernet LAN parameters, including filters, DHCP, and IP address information. These parameters specify the behavior of the router’s local port.

1.From the Main Menu, enter 3 to display Menu 3 - LAN Setup (Figure 7-4).

Menu 3 - LAN Setup

1.LAN Port Filter Setup

2.TCP/IP and DHCP Setup

Enter Menu Selection Number:

Figure 7-4. Menu 3 - LAN Setup

2.Select one of the following submenus:

Menu 3.1 LAN Port Filter Setup

Menu 3.2 TCP/IP and DHCP Setup

Refer to the following sections for descriptions of these submenus. Refer to Table 7-1on page 7-4for information about navigating through the menus.

LAN Port Filter Setup Menu

The LAN Port Filter Setup Menu allows you to apply filter sets to control your Ethernet traffic. Filters are used to block certain packets, to reduce traffic, and to prevent security breaches. You must first create these filter sets using Menu 21, and then apply them by number in this menu.

Refer to Chapter 10, “Configuring Filters ,” for more information about configuring and applying filters.

7-8

Using the Manager Interface for Initial Router Configuration

Page 80
Image 80
NETGEAR RP114 manual Menu 3 LAN Setup