258 Chapter 10 BCM50 Utilities
NN40020-600NN40020-600

Enabling UIP message monitoring

1Click the UIP tab.
2To enable or disable monitoring of MCDN over IP messages for calls made over IP trunks,
select or clear the MCDN over IP check box.
3To select an expansion module, select one of the following from the Bus selection field:
•Bus 3
•Bus 4
•Bus 5
•Bus 6
•Bus 7
•Bus 8
4Select the type of ISDN module or modules:
• PRI — enables monitoring of a DTI module
• BRI — enables monitoring of BRI loops
For example, you can monitor UIP messages for loops 1 and 2 of a BRI module connected to Bus
5 and a PRI module connected to Bus 6. To do this, you would:
• Select Bus 5 - BRI, then select Module 1 - Loop 1
• SelectBus 5 - BRI, then select Module 1 - Loop 2
• Select Bus 6 - PRI

To disable monitoring of UIP messages

1Click the UIP tab.
2From the Bus drop-down list, select the bus you want to disable.
3Select the Off radio button..
Caution: Monitoring UIP messages may affect the performance of the BCM50
system or connected peripherals. For example, if IP sets or voice ports make or
receive a high number of calls over PRI trunks, monitoring UIP increases the
amount of signalling data and may increase the response time for IP sets or voice
ports. Therefore, it is strongly recommended that you monitor only a single UIP
module at a time and restrict the monitoring time.
Note: To disable monitoring of UIP messages for MCDN over IP, you must
deselet the MCDN over IP check box.