25 INSTANT DIAL: Set this function to start reading documents upon “call origination” when transmitting. Available settings are on and off.

Broadcast mode:

Memory available: all the documents are read into the memory before call origination.

Memory full: reading is impossible.

25 Instant Dial = ON:

Memory available: document reading starts upon call origination.

Memory full—Feeder transmission: starts reading document when receiving the CFR signal of the remote machines after call origination.

25 Instant Dial = OFF, 17 Mem./Feeder SW =

MEMORY:

Memory Available: call origination after all documents are read into memory.

Memory Full—Feeder transmission: starts reading document when receiving the CFR signal of the remote machines after call origination.

25 Instant Dial = OFF, 17 Mem./Feeder SW =

FEEDER:

Memory Available—Feeder transmission: starts reading document when receiving the CFR signal of the remote machines after call origination.

Memory Full—Feeder transmission: starts reading document when receiving the CFR signal of the remote machines after call origination.

26 RESTRICT ACCESS: Select whether or not you want restricted access. Turning on this function renders your restricted ID registration active. Available settings are on and off.

Important! You cannot generate a report listing the Restrict Access IDs. Be sure to record all Restrict Access IDs. If you forget a Restrict Access ID, you must contact an Authorized Service Dealer for assistance.

27 WIDTH REDUCTION: Turning this function on enables you to print received data at a slightly reduced width. Use this if you frequently receive documents that are printed edge-to- edge (data appears in the non-printable area of the original).

28 TONER SAVE: This function allows you to select whether to use toner saving during facsimile printing. The settings are on and off.

29 CNG COUNT: This function allows you to switch to a facsimile reception mode at a certain CNG signal quantity (1-5) when the unit is operating in T/F, TAD and as a parallel tele- phone.

30 600DPI FAX TX: When Ex. FINE is selected for TX RESOLUTION, and this function is ON, 600-DPI read is enabled. The settings are on and off.

Programming 55

Page 55
Image 55
Oki 4580 manual Memory, Feeder