Onkyo DTR-7.9 Picture Adjust, Advanced Setup—Continued, Picture Mode, Brightness, Contrast

Advanced Setup—Continued

Picture Adjust

Using Picture Adjust, you can adjust the picture quality and reduce any noise appearing on the screen and set it to that adjustment.

Use the Up and Down [q]/[w] buttons to select the set- tings, and use the Left and Right [e]/[r] buttons to set them.

To view the TV picture while setting, press [Enter].

To return to the previous screen, press the [Return] but- ton.

■Picture Mode

AV receiver comes with three Picture Modes (picture setting patterns): “Mode1” (default), “Mode2”, and “Mode3”.

■Brightness

With this setting you can adjust the picture brightness. Can be adjusted from –20 to +20 in steps of 1 (default is 0).

“–20” is the darkest. “+20” is the brightest.

■Contrast

With this setting you can adjust Contrast.

Can be adjusted from –20 to +20 in steps of 1 (default is 0).

“–20” is the least. “+20” is the greatest.

■Hue

With this setting you can adjust the red/green balance. Can be adjusted from –20 to +20 in steps of 1 (default is 0).

“–20” is the strongest green. “+20” is the strongest red.

■Saturation

With this setting you can adjust saturation.

Can be adjusted from –20 to +20 in steps of 1 (default is 0).

“–20” is the weakest color. “+20” is the strongest color.

■Edge Enhancement

With this setting you can adjust the sharpness of edges in the picture.

Can be adjusted from 0 to +10 in steps of 1 (default is 0). “0” is the softest.

“+10” is the sharpest.

■Default

You can reset the “Picture Adjust” to its default settings. Press the Right [r] button or [Enter] to reset “Picture Adjust” settings.

Note:

For optimal video performance, THX recommends that the “Picture Adjust” be set to its default settings.

■Noise Reduction

With this setting, you can reduce noise appearing on the screen.

Off: Noise reduction off.

Low: Low noise reduction (default).

Mid: Medium noise reduction.

High: High noise reduction.

Notes:

•When the video signals from HDMI input are “1080p”, “Noise Reduction” in the Picture Adjust set- tings is not available.

•The “Picture Adjust” (except “Default”) can also be set using the [Display] button on the remote controller.

1.Press and hold the [Display] button until the setting item appears on the display.

2.Use the Up and Down [q]/[w] buttons to select an item, and use the Left and Right [e]/[r] buttons to change the setting.

105