Onkyo DTR-7.9 instruction manual Disconnect the speaker setup, Microphone

First Time Setup—Continued

6

7

8

After the 3rd to the 5th measure- ment, the following screen appears.

Auto Speaker Setup

Select [Next] to measure the next position, or select [Finish] to calculate

the Audyssey MultEQ room EQ solution.

Next

Finish(Calculate)

Use the Up and Down [q]/[w] but- tons to select an option, and then press [Enter].

Next:

Select “Next” to begin measuring the next measurement position. After the 6th measurement has been taken, the procedure automatically proceeds to step 7.

Finish (Calculate):

Select this if you don’t want to measure any more listening posi- tions and are ready to calculate the results, then go to step 7.

When the measurements are complete, the following screen appears.

Auto Speaker Setup

Calculating...

When the calculations are com- plete, the following screen appears.

Auto Speaker Setup

Review SP Configuration

Subwoofer	:	No
Front	:	Full Band
Center	:	None
Surround	:	None
Surr Back	:	None
Surr Back Ch	:	- - -
Save
Cancel

Use the Up and Down [q]/[w] but- tons to select an option, and then press [Enter].

The options are:

Save:

Save the calculated settings and exit the automatic speaker setup.

Cancel:

Cancel the automatic speaker setup.

Note:

You can view the calculated settings for the speaker configuration, speaker dis- tances, and speaker levels by using the Left and Right [e]/[r] buttons.

9	If you selected “Save”, the results are
	saved, and the following screen
	appears.

Auto Speaker Setup

Saving...

10 Disconnect the speaker setup

microphone.

Auto Speaker Setup

Please, unplug Setup Mic.

Notes:

•When the automatic speaker setup is complete, the “Equalizer Settings” (page 95) will be set to “Audys- sey”.

•You can cancel the automatic speaker setup at any point in this procedure simply by disconnecting the setup microphone.

51