Onkyo DTR-7.9 Low-PassFilter for the LFE Channel, Double Bass, Off THX, Advanced Setup—Continued

Advanced Setup—Continued

Low-Pass Filter for the LFE Channel

This setting is not set automatically by the Automatic Speaker Setup function (see page 49).

With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.

*If you’re using THX-certified speakers, select “80Hz (THX)”.

10 Use the Up and Down [q]/[w] but- tons to select “LPF of LFE”, and then use the Left and Right [e]/ [r] buttons to select a low-pass filter frequency.

The following low-pass filter frequen- cies can be selected: “80Hz (THX)” , “90Hz”, “100Hz”, or “120Hz”.

Continue with step 11 in the next col- umn.

Double Bass

This setting is not set automatically by the Automatic Speaker Setup function (see page 49).

With the Double Bass function, you can boost bass out- put by feeding bass sounds from the front left and right channels to the subwoofer. This function can be set only if the “Subwoofer” setting in step 4 is set to “Yes”, and the “Front” setting in step 5 is set to “Full Band”.

In the speaker setup screen, you can choose how bass information is distributed to your speakers only if you have large front left and right speakers and a subwoofer.

*If you’re using THX-certified speakers, select “Off (THX)”.

11	Use the Up and Down [q]/[w] but-
	tons to select “Double Bass”,

and then use the Left and Right [e]/[r] buttons to select:

On: Double Bass function on (default). Front left and right bass also goes to the sub- woofer simultaneously.

Off (THX):

Double Bass function off.

12	Press the [Setup] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

92