Onkyo DTR-7.9 Front & Rear Panels—Continued, tPRE OUT: ZONE 2 L/R, uu REMOTE CONTROL, xETHERNET

Front & Rear Panels—Continued

sPRE OUT: FRONT L/R, CENTER, SUBWOOFER, SURR L/R, and SURR BACK L/R

This 5.1/7.1 multichannel analog audio output can be connected to the analog audio input on a multi- channel power amplifier for when you want to use the AV receiver solely as a preamplifier. The SUB- WOOFER jack is for connecting a powered sub- woofer.

tPRE OUT: ZONE 2 L/R

This analog audio output can be connected to a line input on an integrated amplifier in Zone 2. See “Connecting Zone 2” on page 114.

uu REMOTE CONTROL

This u(Remote Interactive) jack can be con- nected to an ujack on another u-capable Inte- gra/Onkyo component. The AV receiver’s remote controller can then be used to control that compo- nent. To use u, you must make an analog audio connection (RCA) between the AV receiver and the other AV component, even if they are connected digitally.

vIR IN A/B and OUT

A commercially available IR receiver can be con- nected to the IR IN A or B jack, allowing you to control the AV receiver while you’re in Zone 2, or control it when it’s out of sight, for example, installed in a cabinet.

A commercially available IR emitter can be con- nected to the IR OUT jack to pass IR (infrared) remote control signals through to other components.

w12V TRIGGER OUT (A/B/C)

This output can be connected to the 12-volt trigger input on a component in Zone 2. When Zone 2 is turned on on the AV receiver, a 12-volt trigger sig- nal is output.

xETHERNET

This port is for connecting the AV receiver to home automation equipment and external controllers.

yRS232

This is the RS232 port.

zFRONT L/R, CENTER, SURR L/R, and SURR BACK L/R speakers

These terminal posts are for connecting the front L/R, center, surround L/R, and surround back L/R speakers.

The FRONT L/R and SURR BACK L/R terminal posts can be used with front speakers and surround back speakers respectively, or used to bi-amp the front speakers. See “Bi-amping the Front Speakers” on page 18”.

cr ZONE 2 L/R speakers

These terminals are for connecting speakers in Zone 2. See “Connecting Zone 2” on page 114.

See pages 15-38for connection information.

12