Onkyo DTR-7.9 Adjusting the Volume for Zone, Muting Zones, Adjusting the Tone and Balance of Zone

Zone 2—Continued

Adjusting the Volume for Zone 2

Remote	On the remote controller, press
controller	the [Zone 2] button, and then use
	the VOL [q]/[w] button.

AV receiver On the AV receiver, press the

[Zone 2] button, and then use the

Zone 2 Level Up and Down [q]/ [w] buttons.

Muting Zones

Remote	On the remote controller, press
controller	the [Zone 2] button, and then
	press the [Muting] button.
	To unmute a zone, on the remote
	controller, press the [Zone 2] but-
	ton, and then press the [Muting]
	button again.

Adjusting the Tone and Balance of Zone 2

Zone 2 Tone

,

1		On the AV receiver, press the
		[Zone 2] button.
	AV receiver

2	Press the AV receiver’s [TONE]
	button repeatedly to select
	“Bass”, “Treble” or “Balance”.
3	Use the Tone Plus [ +] and Minus
	[–] buttons to adjust the Bass,
	Treble or Balance.
	• You can boost or cut the Bass or Tre-
	ble from –10 dB to +10 dB in 2 dB
	steps.

•You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps.

Notes:

•Only analog input sources are output by the ZONE 2 PRE OUT and Zone 2 L/R speaker terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it’s connected to an analog input.

•While Powered Zone 2 is being used, listening modes that need surround back speakers (i.e., Dolby Digital EX, DTS-ES, and THX Ultra2 Cinema) are unavailable.

•While Zone 2 is on, ufunctions will not work.

•You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that sta- tion will also be used in Zone 2.

•Zones can also be unmuted by adjusting the volume.

•The Zone 2 level, balance, and tone functions have no effect on the ZONE 2 PRE OUT when the “Zone2 Out” setting is set to “Fixed” (page 117).

119