Zone 2—Continued

Setting the Powered Zone 2

If you’ve connected your Zone 2 speakers to the AV receiver, as explained in “Connecting Your Zone 2 Speakers Directly to the AV receiver” on page 114, you must set the “Powered Zone2” setting to “Act” (Acti- vated).

1

Press the [Receiver] button fol-

 

Remote

lowed by the [Setup] button.

The main menu appears onscreen.

controller

 

If the main menu doesn’t appear, make

 

sure the appropriate external input is

 

selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [Enter]. The “Hardware Setup” menu appears.

7. Hardware Setup

1. Remote Control

2.Zone2

3.Tuner

4.Analog Multich

5.HDMI

6.Network

3

Use the Up and Down [q]/[w] but-

 

tons to select “2. Zone2”, and

 

then press [Enter].

 

 

The “Zone2” menu appears.

 

7–2. Zone2

 

 

Powered Zone2

Not Act

 

Zone2 Out

Fixed

4 Use the Up and Down [q]/[w] but- tons to select “Powered Zone2”, and use the Left and Right [e]/ [r] buttons to select:

Not Act:

Zone 2 L/R speaker terminals not activated (Powered Zone 2 dis- abled).

Act:

Zone 2 L/R speaker terminals acti- vated (Powered Zone 2 enabled).

5

Press the [Setup] button.

 

 

The setup menu closes.

Notes:

When “Act” is selected and Zone 2 turned on, the Zone 2 speakers connected to the Zone 2 L/R speaker terminals output sound, but the surround back speak- ers connected to the SURR BACK L/R speaker termi- nals do not. When “Act” is selected and Zone 2 turned off, the surround back speakers output sound as nor- mal.

Powered Zone2 cannot be used if “Speakers Type” is set to “Bi-Amp” (see page 45).

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

116

Page 116
Image 116
Onkyo DTR-7.9 instruction manual 116, Setting the Powered Zone, Tons to select 2. Zone2