Onkyo DTR-7.9 Basic Operations—Continued, Using the Multichannel DVD Input, American models only

Basic Operations—Continued

Using the Multichannel DVD Input

The multichannel DVD input is for connecting a compo- nent with a 7.1-channel analog audio output, such as a DVD-Audio or SACD-capable DVD player, or an MPEG decoder. See page 26 for hookup information.

Remote	Press the [Multi CH] button.
controller	“Multich” appears on the display.
	Audio from the multichannel DVD
	input will now be used for the DVD
	input source.

Notes:

•While the multichannel DVD input is selected, the Speaker Configuration settings on page 90 are ignored, and signals from the multichannel input are fed to the speakers as they are.

•The multichannel DVD input cannot be used if “Speakers Type” is set to “Bi-Amp” (see page 45).

•This procedure can also be performed on the AV receiver by using its [Multi CH] button.

Adjusting the Bass & Treble

You can adjust the bass and treble for the front speakers, except when the Direct or THX listening mode is selected.

1		Press the [Tone] button repeat-
	AV receiver	edly to select either “Bass” or
		“Treble”.

2	Use the Tone [–]/[+] buttons to
	adjust.

■Bass

You can boost or cut low-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

■Treble

You can boost or cut high-frequency sounds output by the front speakers from –10 dB to +10 dB in 2 dB steps.

Notes:

•This setting is not available when the multichannel DVD input is selected.

•This procedure can also be performed on the remote controller by using [Audio] button (see page 100).

Displaying Source Information

You can display various information about the current input source as follows.

Remote	Press the [Receiver] button, and
controller	then press the [Display] button
	repeatedly to cycle through the
	available information.

Note:

This procedure can also be performed on the AV receiver by using its [Display] button.

The following information can typically be displayed for input sources.

Input source Listening

mode

Signal format* Sampling frequency

*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format and the number of channels is displayed. For some digital input sig- nals, including multichannel PCM, the signal format, number of channels, and sampling frequency is displayed.

Information is displayed for about three seconds, then the previ- ously displayed information reappears.

Setting the Display Brightness

You can adjust the brightness of the AV receiver’s dis- play.

Remote	Press the [Receiver] button, and
controller	then press the [Dimmer] button
	repeatedly to select: Normal,
	Dim, or Dimmer.
	Alternatively, you can use the AV
	receiver’s [Dimmer] button (North
	American models only).

55