Onkyo DTR-7.9 instruction manual Repeat and 7 for each speaker, THX Audio Setup screen appears

Advanced Setup—Continued

6

7

Use the Up and Down [q]/[w] but- tons to select a frequency, and then use the Left and Right [e]/ [r] buttons to adjust the level at that frequency.

You can select: “25Hz”, “40Hz”, “63Hz”, “100Hz”, “160Hz”, “250Hz”, “400Hz”, “630Hz”, “1000Hz”, “1600Hz”, “2500Hz”, “4000Hz”, “6300Hz”, “10000Hz”, or “16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.

The volume at each frequency can be adjusted from –6 to +6 dB in 1 dB steps.

Tip:

Low frequencies (e.g., 160Hz) affect bass sounds; high frequencies (e.g., 6300Hz) affect treble sounds.

Use the Up and Down [q]/[w] but- tons to select “Channel”, and then use the Left and Right [e]/ [r] buttons to select another speaker.

Repeat step 6 and 7 for each speaker.

THX Audio Setup

These settings are not set automatically by the Auto- matic Speaker Setup function (see page 49).

With the “Surr Back Sp Spacing” setting, you can spec- ify the distance between your surround back speakers. If you’re using a THX-certified subwoofer, set the “THX Ultra2/Select2 Subwoofer” setting to “Yes”. You can then apply THX’s Boundary Gain Compensation (BGC) to compensate the perceived exaggeration of low fre- quencies for listeners sitting very close to a room bound- ary (i.e., wall).

You can also set the THX Loudness Plus. When the “Loudness Plus” is set to “On”, it is possible to enjoy even subtle nuances of audio expression at low volume. This result is only available when the THX listening mode is selected.

1	Press the [Receiver] button, fol-
Remote	lowed by the [Setup] button.
	The main menu appears onscreen.
controller
	If the main menu doesn’t appear, make
	sure the appropriate external input is
	selected on your TV.

2

8	Press the [Setup] button.
	The setup menu closes.

Notes:3

•When the listening mode is set to Direct, no effect will be produced.

•The Equalizer settings have no effect on 176.4/ 192 kHz input signals.

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [Enter].

The “Speaker Setup” menu appears.

2. Speaker Setup

1. Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

Use the Up and Down [q]/[w] but- tons to select “6. THX Audio Setup”, and then press [Enter].

The “THX Audio Setup” screen appears.

2–6. THX Audio Setup
Surr Back Sp Spacing	> 4ft
THX Ultra2/Select2 Subwoofer		No
BGC	- - -
Loudness Plus		On

96