Advanced Setup—Continued

Control

This function allows -compatible components connected via HDMI to be controlled with the AV receiver.

Disable: disabled (default).

Enable: enabled.

Notes:

, which stands for Remote Interactive over HDMI, is the name of the system control function found on Integra/Onkyo components. The AV receiver can be used with CEC (Consumer Electronics Con- trol), which allows system control over HDMI and is part of the HDMI standard. CEC provides interopera- bility between various components, however, opera-

tion with components other than -compatible components cannot be guaranteed.

Set to “Disable” when a connected piece of equipment is not compatible or it is unclear whether the equip- ment is compatible or not.

If movement is unnatural when set to “Enable”, change the setting to “Disable”.

Refer to the connected component’s instruction man- ual for details.

Power Control

To link the power functions of -compatible components connected via HDMI, select “Enable”.

Disable: Power Control disabled.

Enable: Power Control enabled.

Notes:

The “Power Control” setting can be set only when the above “Control” setting is set to “Enable”.

HDMI power control only works with -com- patible components that support it and may not work properly with some components due to their settings or compatibility.

When set to “Enable”, power consumption will increase.

When set to “Enable”, regardless of whether the AV receiver is On or on Standby, both audio and video received by an HDMI input will be output by the HDMI OUT for playback on the TV or other compo- nent that’s connected to the HDMI OUT.

Refer to the connected component’s instruction man- ual for details.

TV Control

Set to “Enable” when you want to control the AV

receiver from an -compatible TV that is con- nected to HDMI.

Disable: TV Control disabled.

Enable: TV Control enabled.

Notes:

Set to “Disable” when the TV is not compatible or when it is unclear whether the TV is compatible or not.

The “TV Control” setting can be set only when the above “Control” and “Power Control” settings are both set to “Enable”.

Refer to the connected component’s instruction man- ual for details.

Note:

After changing the settings of the “Control”, “Power Control”, or “TV Control”, turn off the power to all connected pieces of equipment and then turn on again. Refer to the User’s Manuals for all connected pieces of equipment.

Network

These settings are for use with home automation equip- ment and external controllers.

111

Page 111
Image 111
Onkyo DTR-7.9 instruction manual 111, Network, Power Control, TV Control