Onkyo DTR-7.9 instruction manual Turning On the AV Receiver, Turning On and Standby

Turning On the AV Receiver

Standby/On

Standby indicator

On/Standby

Receiver

Turning On and Standby

AV receiver	Remote
	controller

or

Press the [On/Standby] button.

Alternatively, press the remote controller’s [Receiver] button, followed by the [On/Standby] button.

The AV receiver comes on, the display lights up, and the Standby indicator goes off.

To turn the AV receiver off, press the [On/Standby] button, or press the remote control- ler’s [On/Standby] button. The AV receiver will enter Standby mode. To prevent any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off.

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once.

■ Do the automatic speaker setup—this is essential!

See “Automatic Speaker Setup (Audyssey MultEQ®)” on page 49.
■ Did you connect your TV to the HDMI OUT or COMPONENT
VIDEO MONITOR OUT?
If you did, see “Monitor Setup” on page 40.
■ Have you connected a component to an HDMI input,	HDMI
component video input, or digital audio input?
If you have, see “HDMI Input Setup” on page 42, “Component Video
Setup” on page 43, or “Digital Input Setup” on page 44 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,	OUT IN
or RI Dock?
If you have, see “Changing the Input Display” on page 48.		CD recorder, MD recorder,
	TAPE
		RI Dock

39