Onkyo DTR-7.9 1 2-52, 31, Speaker Level Calibration, Advanced Setup—Continued, Notes

Advanced Setup—Continued

Speaker Level Calibration

This setting is set automatically by the Automatic Speaker Setup function (see page 49).

Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position.

Notes:

•The speakers cannot be calibrated while the output of the AV receiver is muted.

•The test tone is output at the standard level for THX, which is 0 dB (absolute volume setting 82). If you nor- mally listen at volume settings below this, be careful because the test tone will be much louder.

1

2-5 2, 3 1, 6

3

4

Use the Up and Down [q]/[w] but- tons to select “4. Level Calibra- tion”, and then press [Enter].

The “Level Calibration” menu appears and the pink noise test tone is output by the front left speaker.

2–4.	Level Calibration
Left	0.0dB
Center	0.0dB
Right	0.0dB
Surr Right	0.0dB
Surr Back R	0.0dB
Surr Back L	0.0dB
Surr Left	0.0dB
Subwoofer	0.0dB

Note:

Speakers that you set to “No” or “None” on the Speaker Configuration page (page 90) cannot be selected.

Use the Up and Down [q]/[w] but- tons to select each speaker, and use the Left and Right [e]/[r] buttons to set the volume.

The volume can be adjusted from –12.0 to +12.0 dB (–15.0 dB to +12.0 dB for the subwoofer) in 0.5 dB steps.

1

2

Press the [Receiver] button fol- lowed by the [Setup] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [Enter].

The “Speaker Setup” menu appears.

2. Speaker Setup

1. Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

5	Repeat step 4 until the volume of
	the test tone from each speaker
	is the same.
	If you’re using a handheld sound level
	meter, adjust the level of each speaker
	so that it reads 75 dB SPL at the listen-
	ing position, measured with C-weight-
	ing and slow reading.
6	Press the [Setup] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

94