Panasonic AJ-HD1700PE Time code and user’s bit, User’s bit, Setting the internal time code, Free

Time code and user’s bit

Time code

The time code is used when the time code signal generated by the time code generator (time code signal generator) is to be recorded on the tape, its values are to be read by the time code reader (time code signal reader), and the absolute position of the

tape is to be displayed in increments		of	hours,
minutes, seconds and frames.
The time code is written in the sub-code area (data
area) of the helical track. This enables insert editing
to be conducted independently using the time code
alone. In addition, the VTR’s playback speed can be
read from the stop mode to the slow motion playback
up to high-speed playback (approx. 50			k normal
speed or approx. 100	k normal	speed	when using a
DVCPRO tape).

The time code values are indicated on the display and superimposed display.

TCR 00 : 07 : 04 : 23

4 Setting F5RUN MD on the <TC> menu

REC:

The time code advances simultaneously with the recording.

FREE:

The time code advances, like time, irrespective of the VTR operation.

5 Setting F3TCG MD on the <TC> menu

REGEN:

The continuity of the underlying time code in place prior to editing is maintained.

PRE:

The time code can be preset using the operation panel controls or remote controller.

AUTO:

The time code is automatically switched to REGEN

or PRE depending on the VTR’s operation mode: during editing, REGEN is selected; at all other

times, PRE is selected.

t t t t

Hours Minutes Seconds Frames

User’s bit

The “user’s bit” refers to the 32-bit (8-digit) data frame among the time code signals which has been released

to users. It enables operator numbers and other values to be recorded.

The alphanumerics which can be used for the user’s bit are number 0 to 9 and letters A to F.

Setting the internal time code

1 Set the VTR to the stop mode.

6 Registering the TC preset values Display the <HOME> menu.

<TC/UB>

•Preset (in the preset enable status)

1When		among the number keys is pressed,
		T
the	TC display switches to TCG (UBG), and
the	TCG	value characters (all digits) are

highlighted.

2When T is pressed again, one digit is highlighted, and the change enable status is

established.

3Input the desired value using the number

keys. The entire input value can be cleared

by pressing	while		holding down	.
		0

4To input the letters used with the user

press the	same	number		key (toggle	by
tapping		)		holding down		. To
	or		while
	7		8
move from one digit to another, turn the ADJ
dial.
5To enter the value, press the				key.
						ENT

6When the display screen has been changed

during the input	process or if the	button
has been pressed,	the change enable status
is released, and the setting is canceled.

F

’s bit,

F

C

2 Set F3TC/CTL on the <HOME> menu to TC.

3 Set F1 SOURCE on the <TC> menu to INT (for selecting the internal time code).

<CTL>

•Reset

Press F4(TC CLR).

111