Connector signals
PARALLEL REMOTE (50P)
Refer to 50P IN/OUT ASSIGN on the function menu (page 75) for the connection pin signals.
RS-232C
(D-SUB 25-pin, crossover cable supported)
Pin No. | Signal | Description |
|
|
|
|
|
|
1 | FG | Protective ground (frame ground) |
|
|
|
2 | RXD | Received data (data is sent to PC) |
|
|
|
3 | TXD | Transmitted data (data is received |
|
| from PC) |
|
|
|
4 | CTS | Clear to send (shorted with pin 5) |
|
|
|
5 | RTS | Request to send (shorted with pin 4) |
|
|
|
6 | DTR | Data terminal ready (no processing) |
|
|
|
7 | SG | Signal ground |
|
|
|
20 | DSR | Data set ready (+ voltage output after |
|
| communication enable status) |
|
|
|
ENCODER REMOTE(15P)
Pin No. | Signal |
|
|
|
|
1 | FRAME GROUND |
|
|
4 | REM (G) |
|
|
7 | REM RX (X) |
| REMOTE CONTROL PROTOCOL RECEIVE |
|
|
8 | REM TX (X) |
| REMOTE CONTROL PROTOCOL TRANSMIT |
|
|
14 | REM RX (Y) |
| REMOTE CONTROL PROTOCOL RECEIVE |
|
|
15 | REM TX (Y) |
| REMOTE CONTROL PROTOCOL TRANSMIT |
|
|
Printed circuit boards
F1 board (ADDA)
Switch No. |
| What is set |
|
| |
|
| |
SW1 | AUDIO INPUT IMPEDANCE SW | |
| This sets the CH1 audio input impedance. | |
| HIGH/600 | ™ |
|
| |
SW101 | AUDIO INPUT IMPEDANCE SW | |
| This sets the CH2 audio input impedance. | |
| HIGH/600 | ™ |
|
| |
SW201 | AUDIO INPUT IMPEDANCE SW | |
| This sets the CH3 audio input impedance. | |
| HIGH/600 | ™ |
|
| |
SW301 | AUDIO INPUT IMPEDANCE SW | |
| This sets the CH4 audio input impedance. | |
| HIGH/600 | ™ |
|
|
|
H3 board (CUE)
Switch No. | What is set |
|
|
|
|
SW101 | CUE INPUT IMPEDANCE SW |
| This sets the CUE input impedance. |
| HIGH/600 ™ |
|
|
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire or electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified
to do so.
The underlining (__) denotes the factory setting mode.
129
