Panasonic AJ-HD1700PE Variable memory function selection, Outline, established

Variable memory function

Variable memory function selection

Variable memory playback operation procedure

The variable memory mode can be selected by setting

F6 (VARMEM) on the <HOME SHIFT> menu to

“ON.”

When F6(VARMEM) is set to “OFF,” the variable memory mode is canceled, and the regular mode is

established.

<Note>

Bear in mind that when the 23/24 Hz or 25 Hz (HD or SD) mode has been selected as the system menu

item No.25 (SYSTEM FREQ) setting, (VARMEM) F6

will no longer appear on the display and the variable memory mode cannot be selected.

POWER	OFF	ON
		CH	1	2	3	4	5	6	7	8	CUE
		CH CONDITION				MONITOR		FULL/FINE		REMOTE
					L		R		9P	50P	RS-232C

HEADPHONES

SHIFT

F1

F2

F3

F4

AUDIO CH SELECT

ABC

DEF

GHI

CH

1

CH 5 CH

2

CH

6 CH 3

CH

7 CH 4

CH 8

7

8

9

PREVIEW/

PRE-

JKL

MNO

PQRS

REVIEW

ROLL

4

5

6

BS

AUTO

TUV

WXYZ

1

2

3

ENT

EDIT

PUSH

LOCK

0

C

T

F

FULL

REC

P8

REC

P8

REC

P8

REC

P8

6

						2
										EJECT
			XL/L/M			- cassette
				Do not insert S-cassette
					without adapter
			HOME		RF1	RF2ASSEM	ADJUST	SHTL	JOG	VAR
							PUSH-INTER
			VIDEO	UNITY	TC	CUE
						INSERT		REV		FWD
			AUDIO	UNITY	DIAG	MENU
			STAND BY		PLAYER	RECORDER	INPUT CHECK
F5	F6					SERVO	REC INHIBIT
	A IN	A OUT	EDIT		PLAY	REC
	TRIM		REW		STOP	FF
	SET
IN			OUT
										FULL
	1				5				4
3

Outline

This VTR is provided with two variable memory functions, as follows. These functions can be used in the variable memory mode.

Variable memory playback:

Any section of the tape can be played back at variable speeds in the VAR mode, the changes in the speed can be stored in the memory, and the tape can be played back at the memorized speed.

Variable memory editing:

Using the VTR as a controller (recorder in the deck-to- deck mode) to control the playback speed of the player, editing can be performed in the variable speed mode.

To perform variable memory playback operations, set the VTR to the variable memory mode, and take the steps below.

1 Register the IN point using the SET button and IN button. There is no need to set the OUT point for variable memory playback.

2 Set the initial speed ( j1.0 k to i2.0 k) using the search dial while holding down the SET button.

3 When the SET button and PREVIEW/REVIEW button are pressed at the same time, the tape is automatically prerolled and played back at the initial speed setting up to the IN point.

4 After the tape has passed the IN point, turn the search dial to store the playback speed in the memory.

5 Press the STOP button to stop the tape.

6 When the PREVIEW/REVIEW button is pressed, variable memory playback is performed at the memorized speed.

<Notes>

•After passing the IN point, the tape is played back in accordance with the settings in the memory, and

it continues to run at the last speed stored in the memory until the STOP button is pressed.

•Whatever is stored in the memory will be cleared when the VTR exits the variable memory mode. It is also cleared when the POWER switch is set to “OFF.”

36