Panasonic AJ-HD1700PE Registering TCG values, Selecting the values, Inputting numbers and letters

HOME

Function menus

<HOME>

Registering TCG values

1.Selecting the values

Press the
		F3TC/CTL button to select TC.
Press the			. The selected item (cue time
		buttonT
or TC) is now highlighted.
Turn the ADJUST dial to select TC.
Again press	the			A single digit is
			buttonT .

highlighted, and the mode for inputting numerical values is established.

<Notes>

•The UBG value and cue time can be registered in the same way. The CTL value cannot be registered.

•TC or UB can be registered only when the internal time code generator has been selected.

2.Inputting numbers and letters

Press

the

0to

9

number

keys

to

input

numerical values.

Use the

to input A, B and C, and

+F

7

buttons

the

+

buttons to input D, E and F.

F

8

To move the input digit, turn the ADJUST dial.

To input a minus sign, press the

and

F

buttons when the left-most digit is highlighted.

To input a plus sign, press

the

and

F

buttons when the left-most digit is highlighted or

press the

button0 .

(The display goes blank.)

To clear all the digits to zero, press the

and

buttons.

<Notes>

•

When

the

is

tapped

while

the

7button

button is held down, the display changes in the

following sequence: A

> B > C

> A

so on. The same applies when D, E and F are

input using

.

andF

8

•If, when “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the button is released while a letter is being input, the displayed character will be entered.

•Letters can be input only while a UBG value is being registered.

•The input of a minus number is possible only while the cue time is being registered after “d12h” is selected as the setup menu No.002 (TAPE TIMER) setting and CTL is selected by the F3 TC/CTL button.

•If “REV” has been selected as the setup menu item No.144 (TC INPUT) setting, the input starts from the highest order digit (the display appears from the far right). However, turning the ADJUST dial once will restore the NORMAL input mode.

TRIM j ]

TRIM i ]

F 0

F

> B and

F

3.Entering the input values

Press	the				The	value input is
			ENT button.
registered, and the normal display is restored.
<Notes>
• To cancel the registration, press the							button.
• If	the	input value is		outside		the	registration
enable range, the
					INVALIDalarm		blinks, and

the value cannot be registered until it has been corrected.

C

45