3.1Loading Media

nThe following procedures explain the preliminary label loading steps.

oRaise the Access Cover.

Rotate the Printhead Latch pforward to raise the printhead.

Slide the Label Guide out away from the frame and then lower it to the down position.

Note: In this left-justified printer, always place the labels against the

qbackstop when loading.

rPull outward on the Roller Bracket and allow it to swing down.

Load labels and advance approximately 20 inches of labels from the front of the printer. Remove the labels from the entire length, leaving only the backing material.

J693

7

Page 17
Image 17
Pitney Bowes J693 manual Loading Media