Pitney Bowes J693 manual 4.1.6, Diagnostics

4.1.6			Diagnostics
HEX DUMP MODE					Most commonly used mode for trouble
					shooting. Prints data and instructions
					received from the host rather than
					interpreting them (see Section 6.2).
	ENABLE				Prints raw ASCII data received from the
					host rather than executing the
	ó				commands.
	DISABLE				Executes and prints label formats
					(normal operating mode).
OPTIONS TESTING					Tests currently installed options
	TEST PRESENT SENSOR				Performs a functional test of the Present
					Sensor circuitry.
	TEST CUTTER				Performs a functional test of the
					optional cutter mechanism and circuitry.
		PERFORM TEST			The cutter will cycle 1, 10 or 100 times
		1 TIME			(user selects). The results of each
					attempt will be displayed.
TEST					Tests the optional GPIO port, when
					installed.
	MONITOR GPIO INPUT				Performs a functional test of the GPIO
					input circuitry.
	MONITOR GPIO OUTPUT				Performs a functional test of the GPIO
					output circuitry.
SENSOR READINGS					All Analog Sensor readings displayed
	THR TRAN RIBM 24V->				Live sensor values may be viewed. View
	255		255	255 255	is toggled with forward and reverse
					keys. Maximum values are shown here:
					thermistor sensor, transmissive (gap)
					media sensor (TRAN is replaced with
					REFL when SENSOR TYPE is set to
					reflective), ribbon motion sensor, 24 volt
					power supply sensor.
	<- PS HD RANK				present sensor, head down, printhead
	255 255			255	ranking resistor.
RIBBON SENSOR LIMITS					Displays ribbon sensor ADC low and
					high values. A Level 2 reset is required
					to change these values.
	RIBBON ADC LOW HIGH				Approximate default values are shown
				070 104	here (actual values will vary).
30					J693