Pitney Bowes J693 manual Updating the Application Program, Cleaning Interior and Exterior Surfaces

5.5.3Cleaning Interior and Exterior Surfaces

Interior Surfaces: During operation, dust particles from the media build-up inside the printer. Then, as the media is pulled through the printer, the particles can become attached and cause voids on the printed labels. To prevent this, turn ‘Off’ and unplug the printer. Remove all media. Using a soft bristle brush or compressed air, clean out the interior of the printer.

Exterior Surfaces: The outer surfaces of the printer should be cleaned using a general-purpose cleanser. Never use abrasive cleansers or solvents. To clean, turn ‘Off’ and unplug the printer. Using a soft cloth or sponge dampened with the cleanser, wipe the exterior surfaces until clean.

5.6Updating the Application Program

The printer stores its application program in Flash memory on the Main PCB. A feature is included that allows updates to this program through any printer interface port. Updates can be found on our web site. There are two modes in which the firmware of the printer can be updated: (1) the Ready Mode, or (2) the Download Mode.

Should an error occur during the file download (see Section 5.6.3), the update is aborted. If this process did not reach ‘Erasing Flash’ or ‘ Updating Software’, the previous program is left intact;

WARNING otherwise, a successful download must be completed before the printer is operable.

Note: After updating from 2.xx to 3.xx firmware for the first time, you must also download the EFIGS menu language file and copy 832296.01C (or most current version) to lpt1: /b (the DOS Copy command requires the /b parameter because this file contains binary code).

Before beginning an update, identify the current version of the printer’s application program by printing a Configuration Label (see Section 4.3.2). Compare that version string to those filenames available from our web site and then download the desired file onto your computer’s hard drive.

Proceed with the printer update accordingly:

If the current application version is 2.091 or greater, refer to Section 5.6.1

yor Section 5.6.2.

If the current application version is 2.08 or less, start with Section 5.6.2.

J693 59