Calibration Problems: If problems occur during calibration, one of the following messages will be displayed. The ‘Comment’ column addresses the most likely cause and the corrective action to be taken (if any) for each situation.

 

Displayed Message

Action

Comment

 

 

 

 

Press any key.

The printer measured only a small

 

 

￿

 

 

￿"￿￿￿￿￿￿￿￿#"￿￿￿￿￿

 

 

difference between the ‘empty’ and

 

 

 

 

 

 

 

‘gap’ readings. Transparent

 

 

 

 

 

 

 

 

 

 

backing or notched type media

 

 

 

 

 

typically gives this indication. In

 

 

 

 

 

this case, there may be a slight

 

 

 

 

 

delay in the ‘Out of Stock’

 

 

 

 

 

indication, after the media supply is

 

 

 

 

 

emptied.

 

 

 

 

 

Or:

 

 

 

 

 

 

 

 

 

Displayed Message

Action

Comment

 

 

 

 

Press any key.

Only a small difference or no

 

 

￿￿

 

 

￿"￿￿￿￿

"￿￿#￿"￿￿

 

 

change in low sensor readings was

 

 

 

 

 

detected. Ensure that nothing is

 

 

 

 

 

 

 

 

 

 

stuck in the media sensor. Retry

 

 

 

 

 

calibration. If the problem persists,

 

 

 

 

 

perform the ‘Advanced Entry

 

 

 

 

 

Calibration’; see Section 5.2.2. If in

 

 

 

 

 

reflective mode – REFLECTIVE

 

 

 

 

 

MODE will be displayed instead of

 

 

 

 

 

GAP MODE.

 

 

 

 

 

Or:

 

 

 

 

 

 

 

 

 

Displayed Message

Action

Comment

 

 

 

 

Press any key.

Consistently high readings were

 

 

￿￿

 

 

￿"￿￿￿￿

￿￿￿￿￿

 

 

received which could indicate a

 

 

 

 

 

faulty sensor. Ensure that no labels

 

 

 

 

 

 

 

 

 

 

are stuck in the media sensor. Retry

 

 

 

 

 

calibration. If the problem persists,

 

 

 

 

 

call for service.

 

 

 

 

 

When in reflective mode –

 

 

 

 

 

REFLECTIVE MODE will be

 

 

 

 

 

displayed instead of GAP MODE.

 

 

 

 

 

 

 

 

 

 

 

 

46

 

 

 

J693

Page 56
Image 56
Pitney Bowes J693 manual Displayed Message Action Comment