Pitney Bowes J693 manual Step Operator Action Displayed Message Comment

Three Media Sensor readings are required:

Empty: Nothing in the sensor.

Mark or Gap: Only the backing material, notch, or reflective mark in the sensor.

Paper:		The label (with the backing material attached) in the sensor.
To perform a Standard Calibration:
Step		Operator Action		Displayed Message	Comment
1	Turn ‘On’ the printer.				Wait until
				￿￿"￿￿	‘Ready’ is
					displayed.
2					See Section
	Press the		key to enter	￿
				￿￿￿￿"￿￿￿￿￿￿￿￿	4.0.2 for
	Menu Mode.				details.

Raise the printhead for visual access to the Media Sensor and load label media.

3	Press the		key to			See Section
					￿￿￿￿
	enter the Media Settings				￿￿￿￿"￿￿￿￿	4.1.1 for
	menu.					details.
4	Press the		key.			See Section
					"￿￿￿￿
					￿￿￿￿￿￿￿￿￿￿	4.1.1 for
						details.
5	Press the		key. Use			See Section
					￿￿￿￿￿￿￿￿
	the	key to scroll			J￿"￿	4.1.1 for
	to the desired sensor type					details.
	and press the			key		The enabled
	to enable the selection.
						selection will
						be indicated
						with an *.
(Continued next page)
42						J693