Pitney Bowes J693 manual Jqqhqlrvi

Step

Operator Action

Displayed Message

Comment

10

Proceed according to media type:

Die-cut stock: remove approximately six inches of label material from the backing and place the backing under the Sensor Eye Mark. Lower the printhead.

Notched stock: place the notched area in the sensor and adjust the Sensor Eye Mark over the notch.

Lower the printhead.

Reflective stock: place the black mark (face down) in the sensor and adjust the Sensor Eye Mark over the mark. Lower the printhead.

Using the key increment the Gain Number. Press the key to select the new setting and then record the sensor reading (the ‘yyy’ value).

Repeat this process for each of the 16 Gain Numbers, recording each value.

JQQ￿"￿￿￿￿"￿HQ]<<<LRVI

-OR-

￿￿￿￿

‘yyy’ is a numerical value representing the current sensor reading.

Note:

After the Media Sensor has been adjusted, do not readjust the position.

These are the TOF Values.

(Continued next page)

J693 49